Expert Answers about Dutchmen Astoria Fifth Wheel

• Will TorkLift GlowStep Revolution RV Steps Fit A 2021 Dutchmen Astoria 5th Wheel Trailer
• Hey Jim, There unfortunately isn't a guide to tell us what steps were installed by the manufacturer in your 2021 Dutchmen Astoria so we'll need to take a few measurements first to determine compatibility. The first measurement is going to be the width of the narrowest part of the door frame. There should be a flange on both sides of the door that prevents the door from swinging into the camper. The steps will sit between these flanges so we need to know how much space we're working with....
  view full answer...


• Can Adco Olefin HD RV Cover for 5th Wheel Toy Haulers up to 31' Fit Non-Toy Hauler
• Yes, the Adco Olefin HD RV Cover for 5th Wheel Toy Haulers up to 31' Long # AD99ZR that you referenced will work on your non-toy hauler 5th wheel camper. The only difference a toy hauler cover would have would be that it has a rear door that can zipper off for access to the back of the RV.
  view full answer...


• Backup Camera & Monitor For Trailer Pre-Wired With Voyager WiSight Plate
• Thanks so much for the photo, it was super helpful, and what it shows is that your trailer has the Voyager WiSight Pre-Wire Plate. This will allow you to mount the Voyager WiSight camera system: - Voyager WiSight Wireless RV Backup Camera System # ASA24YR This camera is super easy to install because your trailer was pre-wired; all you need to do for the camera is remove the plate, which is held in by screws, and there will be a connector under the plate for the camera. Then mount the...
  view full answer...


• How To Find Gen-Y Pin Box To Gooseneck For a Dutchman Astoria 2993RLF 5TH Wheel Camper
• It does appear you will want the Gen-Y Hitch 5th Wheel to Gooseneck Pin Box # GY58GR you found on your Dutchman Astoria 2993RLF. I can verify this is the correct pin box if you can give me all the information off the Lippert tag found on the mounting arm which the pin box bolts too. Otherwise you can verify with a few measurements. You said the bolt spacing is 8" but I think it is actually 7-7/8" from front to back on center. The holes will be spaced 2" vertically and the pin box will be...
  view full answer...


• Will The Correct Track Trailer Alignment and Lift Kit # RR23QX Work On A 2023 Dutchmen 2533RDF
• Hello David. The Correct Track Trailer Alignment and Lift Kit # RR23QX is definitely going to be your best bet for lifting your 2023 Dutchmen 2533RDF. That said, this kit is not made for any one specific camper, so we generally would want you to check and confirm fitment. Basically, you will want to be sure that there is at least 2-5/8" from the I-beam to the spring mounting hole on the hanger. Based on your picture it looks like there is definitely enough room, but I am just eyeballing....
  view full answer...